Skip headerimage
ManualsContentsPreviousNextHelp

Installing the Gigabit Ethernet Board

Important

  1. Check the contents of the package.

    Interface unit contents numbered callout illustration

    1. Gigabit Ethernet Board

    2. One Protective Cap

    3. Two Ferrite Cores

      Use the included ferrite cores when connecting an Ethernet cable to the board.

    4. Two coin screws

  2. Turn the printer off and unplug the power cord.

  3. Unplug the cable from the Ethernet port, and then cover it with the protective cap.

    Controller board illustration

  4. Loosen the screw and remove the slot cover.

    Controller board illustration

    The removed cover will not be reused.

  5. Remove the 5 screws securing the controller board.

    Controller board illustration

    The removed screws will be used to secure the controller board again later.

  6. Holding the handle, carefully pull out the controller board.

    Slide the controller board completely out, and then place it on a flat surface such as a table.

    Controller board illustration

    Use both hands to slide the controller board completely out.

    Controller board illustration

  7. Install the Gigabit Ethernet board in the indicated position.

    Controller board illustration

    Install the hard disk carefully if the SDRAM module is already installed. If the hard disk comes in contact with the SDRAM module, the SDRAM module may become damaged.

  8. Carefully insert the Gigabit Ethernet board vertically, all the way to the back.

    Controller board illustration

    Push the Gigabit Ethernet board all the way to the back, and confirm that it is securely connected to the controller board.

  9. Use 2 coin screws to fasten the Gigabit Ethernet board to the controller board panel.

    Controller board illustration

  10. Fit the controller board into the printer, and push it carefully until it stops.

    Controller board illustration

    Push it firmly into the printer using the handle. The printer may malfunction if the controller board is not properly installed.

  11. Fasten the controller board to the printer using the five screws.

    Controller board illustration

Note

Reference