Skip header
 

Top Page > Software Guide > Monitoring and Configuring the Printer > Using SmartDeviceMonitor for Admin > Installing SmartDeviceMonitor for Admin

Installing SmartDeviceMonitor for Admin

Follow the procedure below to install SmartDeviceMonitor for Admin.

1Quit all applications currently running.

2Insert the CD-ROM into the CD-ROM drive.

The installer starts.

3Select an interface language, and then click [OK].

The default interface language is English.

4Click [SmartDeviceMonitor for Admin], and then click [Next>].

The software license agreement appears in the [License Agreement] dialog box.

5After reading through its contents, click [Next>].

6Follow the instructions on the screen.

A message appears when the installation is completed.

7Click [OK].

A message about restarting the computer may appear. Restart the computer to complete installation.

Note

  • Auto Run may not work under certain operating system settings. In this case, launch “Setup.exe” located on the CD-ROM root directory.

  • If you are required to restart the computer after installing SmartDeviceMonitor for Admin, restart the computer and continue the configuration.