Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Hardware Guide > Replacing Consumables > Adding Staples > When the Booklet Finisher is Installed

When the Booklet Finisher is Installed

  1. Open the front cover of the finisher.

    Booklet finisher illustration

  2. Holding the R7 lever, pull out the staple unit.

    Staple illustration

  3. Raise the lever.

    Staple illustration

  4. Holding the lever on the cartridge, pull the cartridge gently out of the staple unit.

    Staple illustration

  5. Pushing both sides of the cartridge, pull out the upper unit.

    Staple illustration

  6. Take out the empty staple case.

    Staple illustration

  7. Push the new case into the cartridge until it clicks.

    Staple illustration

  8. Lower the upper unit carefully.

    Staple illustration

  9. Pull the ribbon out of the staple case that you attached.

    The ribbon rolls around the staple case. Make sure to pull it out completely.

    Staple illustration

  10. Holding the lever on the cartridge, push the cartridge gently into the staple unit until it clicks.

    Staple illustration

  11. Push the lever down until it clicks.

    Staple illustration

  12. Return the staple unit to its original position.

  13. Close the front cover of the finisher.

Note

TopPreviousNext
Copyright (C) 2008