Enabling SSL
After installing the device certificate in the machine, enable the SSL setting.
This procedure is used for a self-signed certificate or a certificate issued by a certificate authority.
Open a Web browser.
Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is "192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
Click [Login].
The administrator can log on.
Enter the login user name and login password.
Click [Configuration], and then click [SSL/TLS] under “Security”.
The “SSL/TLS” page appears.
Click [Active] for the protocol version used in “SSL/TLS”.
Select the encryption communication mode for “Permit SSL/TLS Communication”.
Click [OK].
The SSL setting is enabled.
Click [OK].
Click [Logout].
If you set “Permit SSL/TLS Communication” to [Ciphertext Only], enter "http://(the machine's IP address or host name)/" to access the machine.
