Skip header
 

Top Page > Hardware Guide > Troubleshooting > Using the Envelope Lever

Using the Envelope Lever

CAUTION

  • The inside of the machine becomes very hot. Do not touch the parts with a "image" label (means hot surface). Touching a part with a "image" label (means hot surface) could result in a burn.

  • The fusing unit becomes very hot. When installing the new fusing unit, turn off the printer and wait about an hour. After that, install the new fusing unit. Not waiting for the unit to cool down can result in a burn.

1Open the rear cover.

Rear side of the printer illustration

2If the optional duplex unit is attached, push down the lever on the right side of the duplex unit (image), and then pull it out until it stops (image).

Duplex unit illustration

3Push the under board levers (image) and then pull the duplex unit out of the printer (image).

Duplex unit illustration

4Use the envelope lever.

Lowering the envelope lever increases roller pressure.

Rear side of the printer illustration

Keep the envelope lever lowered when printing normally.

5Close the rear cover.

Rear side of the printer illustration

6When the optional duplex unit was removed, push in the duplex unit along the rail in the back of the printer.

Duplex unit illustration

7Securely push the duplex unit into the printer.

Duplex unit illustration