Skip header
ManualsContentsPreviousNextHelp

Top Page > Software Guide > Making Printer Settings Using the Control Panel > PS Menu > PS Menu Parameters

PS Menu Parameters

This section explains about parameters that can be set on the PS menu.

Job Timeout

You can specify how long the printer waits (in seconds) before cancelling the current job when the job is interrupted while being processed.

  • Driver/Command

  • Machine Setting

Note

  • Default: Driver/Command

  • If you select Machine Setting, enter a value between 0 and 999. (Default: 0)

Wait Timeout

You can specify how long the printer waits (in seconds) before it cancels receiving the job when the printer cannot detect the end of the job.

  • Driver/Command

  • Machine Setting

Note

  • Default: Driver/Command

  • If you select Machine Setting, enter a value between 0 and 999. (Default: 300)

Data Format

You can select the data format.

  • Binary Data

  • TBCP

    This setting is effective when using a parallel, USB, or EtherTalk connection.

    When you use a parallel or USB connection, the print job is canceled if binary data is sent from the printer driver.

    When you use an Ethernet connection, the print job is canceled if:

    • The printer driver data format is TBCP and the data format selected using the control panel is Binary Data.

    • The printer driver data format is binary and the data format selected using the control panel is TBCP.

Note

  • Default: TBCP

Resolution

You can select the resolution.

  • 300dpi

  • 600dpi Fast

  • 600dpi

Note

  • Default: 600dpi Fast

TopPreviousNext
Copyright (C) 2008