Maintenance Menu Parameters

This section explains about parameters that can be set on the Maintenance menu.

Image Density

You can select the print image density.

-6 to 3

Registration

You can adjust the starting position of the printing page.

Prt. Test Sheet
You can print the registration test sheet.
Tray 1, Tray 2, Tray 3, Bypass Tray, Duplex Unit
- Only the installed trays appear on the display panel.
Adjustment
You can select the start position for printing on a page.
Horiz.:Tray 1, Horiz.:Tray 2, Horiz.:Tray 3, Horiz.:Bypass, Horiz.:Dup.Back, Vert.:Std. Tray, Vert.:Opt. Tray, Vert.:Bypass, Vert.:Dup.Back
- Only the installed trays appear on the display panel.

Curl Prevention

You can control the fuser temperature to prevent paper from curling.

Del. All Temp

This appears on the menu only when the hard disk is installed.

Use this function to delete all temporarily saved documents (Sample Print, Locked Print and Hold Print data) at once.

Del. All Stored

This appears on the menu only when the hard disk is installed.

Use this function to delete all saved documents (Stored Print data) at once.

HD Format

Appears when the hard disk is installed.

Reset IPDS Fonts

Use this page to delete all IPDS captured fonts.

Date/Time

Use this to set the date and time.

WL.LAN Signal

You can check the signal strength when using LAN.

The menu appears when the Wireless LAN interface unit is installed.

WL.LAN Defaults

Reset the wireless LAN to default.

The menu appears when the Wireless LAN interface unit is installed.

Panel Key Sound

You can select whether or not to sound the beeper when the control panel is pressed.

For details about meaning of the various beep patterns, see "Panel Tone", Hardware Guide.

Warm-Up Beeper

You can select whether or not to sound the beeper when the warming up is completed.