Making Enlarged or Reduced Copies

This section describes how to specify the reduction or enlargement ratio for the current job.

Scaling

There are two ways to set the scaling ratio: using a preset ratio or manually specifying a customized ratio.

Preset ratio
50%, 65%, 78%, 93%, 129%, 155%, 200%, 400%
50%, 71%, 82%, 93%, 122%, 141%, 200%, 400%
Custom ratio
25% to 400% in 1% increments.

Making enlarged or reduced copies

Use this procedure to enlarge or reduce the size of your copies.

Press the [Reduce/Enlarge] key.
Press the [Reduce/Enlarge] key or [][] keys to select the desired ratio, and then press the [OK] key.
If [Custom 25-400%] has been selected, specify the desired ratio using the number keys, and then press the [OK] key.
- Use the following keys to cancel settings:
  - []: Cancels the changes made to settings and returns the display to the previous screen.
  - [Clear/Stop]: Cancels the changes made to settings and returns the display to the initial screen.
- You can change the [Reduce/Enlarge] setting under [Copy Settings] to always make photocopies in the specified ratio.
- Temporary job settings are cleared in the following cases:
  - When no input is received for the period of time specified in [Auto Clear] while the initial screen is displayed.
  - When the [Clear/Stop] key is pressed while the initial screen is displayed.
  - When the machine's mode is changed.
  - When the power is turned off.
  - When the machine's default for the same setting is changed.
- For details about [Reduce/Enlarge], see Copy Settings.
- For details about [Auto Clear], see Administrator Settings.