Skip header
 

Replacing the Waste Toner Bottle

WARNING

  • Do not incinerate spilled toner or used toner. Toner dust might ignite when exposed to an open flame.

  • Wait at least 30 minutes after disconnecting the power plug before removing the transfer unit.

  • Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame. Dispose of used toner containers in accordance with local regulations.

CAUTION

  • The inside of this machine becomes very hot. Do not touch parts labelled “” (indicating a hot surface).

  • Keep toner (used or unused) and toner containers out of reach of children.

Messages on the screen

  • Replace the waste toner bottle when the following message appears on the screen:

    “Life End Waste Toner Bottle”

  • Prepare a waste toner bottle when the following message appears on the screen:

    “Near End Waste Toner Bottle”

Important

  • Waste toner bottles cannot be reused.

  • For easy replacement, we recommend you purchase and store extra waste toner bottles.

  • When removing the waste toner bottle, make sure not to tilt it.

  • Make sure the transfer unit is installed. If the transfer unit is not installed, install it before turning on the power.

  • Comply with the waste toner bottle Recycling Program, whereby used waste toner bottles are collected for recycling.

  • Before removing the waste toner bottle from the machine, spread paper or similar material around the area to keep toner from dirtying your workspace.

1Pull the opening lever on the front cover, and then carefully lower the front cover.

image

2Slide both green levers on the front cover.

image

3Holding the green tabs on both ends of the transfer unit, tilt it backwards then lift it up.

image

4Hold the center of the waste toner bottle, and then carefully pull it partially out without tilting it.

image

5Pull the waste toner bottle halfway out, grab the bottle firmly, and then pull it straight out.

image

image

To prevent the waste toner bottle touching the intermediate transfer unit (the white area in the illustration below), do not lift the bottle while pulling it out.

image

6Close the bottle cap.

image

image

7Hold the center of the new waste toner bottle, and then carefully insert it halfway into the machine body.

Leave the bottle cap open.

image

To prevent the waste toner bottle touching the intermediate transfer unit (the white area in the illustration below), do not lift the bottle while inserting it.

image

8Push in the waste toner bottle until it clicks into place.

Push the green part all the way in.

image

9Place the transfer unit down on the front cover.

image

10Slide the transfer unit along the guide rails into the machine. When it stops, push on the green PUSH mark until it clicks into place.

image

11Using both hands, carefully push up the front cover until it closes.

image

Note

  • When closing the front cover, push the upper area of the cover firmly.

  • Comply with the waste toner bottle Recycling Program, whereby used waste toner bottles are collected for processing. For details, ask your sales or service representative.