Types of paper

Thinner Paper

60-65

Thin Paper (66-74g/m²)

66-74

Plain Paper 1

75-90

• Default

Plain Paper 2 (91-105g/m²)

91-105

• The number of sheets that can be printed in one minute is approximately half that of Plain Paper 1.

Recycled Paper

75-90

• If the paper thickness is outside the specified range, select Thin Paper, Plain Paper 2 (91-105 g/m²) or Thick Paper.

Color Paper

75-90

Preprinted Paper

75-90

Prepunched Paper

75-90

Thick Paper 1 (106-160g/m²)

106-160

• The number of sheets that can be printed in one minute is approximately half that of Plain Paper 1.

Thick Paper 2 (161-200g/m²)

161-200

• The number of sheets that can be printed in one minute is approximately 0.4 times that of Plain Paper 1.

• Paper can be loaded only up to the lower of the two paper limit marks of the bypass tray.

Letterhead

75-90

• Paper that has a thickness outside the specified range cannot be printed.

Bond Paper

105-160

• The number of sheets that can be printed in one minute is approximately half that of Plain Paper 1.

• If the paper thickness is outside the specified range, select Plain Paper 2 (91-105 g/m²).

Cardstock

105-160

• The number of sheets that can be printed in one minute is approximately half that of Plain Paper 1.

• Paper thicker than 160g/m² cannot be printed.

Label Paper

• The number of sheets that can be printed in one minute is approximately half that of Plain Paper 1.

Envelope

• The number of envelopes that can be printed in one minute is approximately half that of Plain Paper 1.

• Paper can be loaded only up to the lower of the two paper limit marks of the bypass tray.

• To prevent the envelopes becoming creased, go to the [Setup] tab and select [Rotate by 180 degrees] for [Orientation:] when printing.

• If printed envelopes come out badly creased, load the envelopes in the opposite direction. Also, configure the printer driver to rotate the print object 180 degrees.

• Load envelopes print side down in the bypass tray.

  

• The load envelopes that open along the long edge, set the flap edge against the left paper guide. If the flap of the envelope is folded closed, set the flap edge flush against the left paper guide. If the flap of the envelope is open, set the envelope with the tip of the open flap against the left paper guide.

  

• To correctly specify the length of an envelope whose flap opens along its short edge, be sure to include the open flap when measuring.

  

• Environmental factors can degrade the print quality on both recommend and non-recommended envelopes.

• Fan envelopes, and then align their edges before loading.

  

• When fanning envelopes, make sure they are not stuck together. If they are stuck together, separate them.

• When fanning envelopes, make sure the envelope flaps are not stuck together. If they are stuck together, separate them.

• Before loading envelopes, flatten them out so that their curl does not exceed that shown in the illustration below.

  

  If the curl is severe, flatten out the envelopes using your fingers, as shown in the illustration below.

  

• If envelopes are severely curled after printing, flatten them by bending them back against the curl.

• After printing, envelopes sometimes have creases along their long edges and toner smear on their unprinted sides. Their print images might also be blurred. When printing large, black-solid areas, striping can occur as a result of the envelopes overlapping.