authfree

Use the "authfree" command to view and configure AuthFree parameters.

View settings

The following command displays the current AuthFree settings:

msh> authfree

If print job authentication exclusion is not set, authentication exclusion control cannot be displayed.

IPv4 address settings

msh> authfree "ID" range_addr1 range_addr2

IPv6 address settings

msh> authfree "ID" range6_addr1 range6_addr2

IPv6 address mask configuration

msh> authfree "ID" mask6_addr1 masklen

USB settings

msh> authfree usb [on|off]

To enable authfree, set to on. To disable authfree, set to off. Always specify the interface.

Authentication exclusion control initialization

msh> authfree flush