ManualsContentsPreviousNext |
This section describes how to remove punch waste.
While "Hole Punch Receptacle is full." is displayed, you cannot use the Punch function.
"Hole Punch Receptacle is full." is displayed until the punch waste box is reinstalled.
If the message is still displayed, reinstall the punch waste box.
Open the finisher left cover.
Open the finisher right cover
Pull out the punch waste box carefully, and then remove punch waste.
Reinstall the punch waste box.
Close the finisher right cover.
Close the finisher left cover.
"Hole Punch Receptacle is full." disappears.