Skip header
 

Auto Color Calibration

This section describes Auto Color Calibration.

1Press the [User Tools / Counter] key.

User Tools/Counter key illustration

2Press [Maintenance].

Operation panel screen illustration

3Press [Auto Color Calibration].

4Press [Start].

When performing auto color calibration from the copy function, press [Start] under Copier Function. When performing auto color calibration from the printer function, press [Start] under Printer Function.

Operation panel screen illustration

5Press [Start Printing] and a test pattern is printed.

  • Copier Function

    Operation panel screen illustration

  • Printer Function

    When performing auto color calibration from the printer function, select test patterns from [Test Pattern 1 (600 multiplication 600 dpi)], [Test Pattern 2 (1800 multiplication 600 dpi)], or [Test Pattern 3 (1200 multiplication 1200 dpi)], and then press [Start Printing].

    Operation panel screen illustration

6Place the test pattern on the exposure glass and press [Start Scanning].

The image will be corrected after “Scanning...Please wait.” disappears.

Note

  • The test pattern will not be read if it is set in the ADF.

  • The test pattern will be printed on an A4, 81/2 multiplication 11 size page. If A4 is not available, A3 or B4 JIS (Japanese Industrial Standard) will be used. Make sure to check the paper set in the paper tray.

  • Set the test pattern in the following way:

    Illustration of setting the test pattern

  • Make sure to set the test pattern on the exposure glass, and then 2 or 3 white sheets, same size as the test pattern, above the test pattern.