Manuals
Contents
Previous
Next
| | | |
| |||
| |||
| | | |
| ManualsContentsPreviousNext | | |
Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, trap, lpr, ipp, ftp, sftp, wsd (printer), and smb (TCP/IP) protocol.
The "spoolsw" command for configuring Job Spool settings is available only when the optional hard disk is installed.
View settings
The Job Spool setting appears.
msh> spoolsw
Job Spool setting
msh> spoolsw spool {on|off}
Specify "on" to enable Job Spool, or "off" to disable it.
Resetting Job spool setting
msh> spoolsw clear job {on|off}
When the printer power is cut during job spooling, this determines whether to reprint the spooled job.
Protocol configuration
msh> spoolsw diprint {on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
msh> spoolsw wsprn {on|off}
 |
 | Copyright (C) 2008 |
