Skip header
ManualsContentsPreviousNextHelp

Top Page > Network and System Settings Guide > Connecting the Machine > Connecting to the Interfaces > Connecting to the Ethernet Interface

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.

Important

  1. A ferrite core for the Ethernet interface cable is supplied with this machine. Attach the ferrite core about 10 cm ( 4 inch) (1) from the machine end of the cable.

    illustration of Ethernet cable with ferrite core

  2. Make sure the main power switch of the machine is off.

  3. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

    illustration of connecting the Ethernet interface cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    10BASE-T/100BASE-TX port illustration (numbered callout illustration)

    1. Indicator (green)

      Lights up green when the machine is connected correctly to the network.

    2. Indicator (yellow)

      Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.

    Note

    • For details about how to turn on the main power switch, see "Turning On the Main Power", About This Machine.

    • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.

TopPreviousNext
Copyright (C) 2008