Skip header
 

Top Page > Network and System Settings Guide > Registering Addresses and Users for Facsimile/Scanner Functions > Registering Folders > Registering an NCP folder > Locating the NCP folder manually

Locating the NCP folder manually

This section describes how to locate the NCP folder manually.

1Press [Change] under "Path".

2Enter the path where the folder is located.

3Press [OK].

4Press [Connection Test] to check the path is set correctly.

5Press [Exit].

Note

  • If you set "Connection Type" to [NDS], and if the NDS tree name is "tree", the name of the context including the volume is "context", the volume name is "volume" and the folder name is "folder", then the path will be "\\tree\volume. context\folder".

  • If you set "Connection Type" to [Bindery], and if the NetWare server name is "server", the volume name is "volume" and the folder name is "folder", then the path will be "\\server\volume\folder".

  • You can enter a path using up to 256 characters.

  • If the connection test fails, check the settings, and then try again.