autonet
Use the “autonet” command to configure AutoNet parameters.
View settings
The following command displays the current AutoNet settings:
msh> autonet
Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
{on} means “active” and {off} means “inactive”.
Current interface priority configuration display
msh> autonet priority
Interface priority configuration
msh> autonet priority “interface_name”
You can give interface's AutoNet parameter priority.
Priority settings are available when multiple interfaces are installed.
wlan can be specified only when the IEEE 802.11 interface is installed.
Interface |
Interface configured |
|---|---|
ether |
Ethernet interface |
wlan |
IEEE 802.11 interface |
If an interface is not selected, the current interface connection settings remain in effect.
For details about AutoNet, refer to autonet parameters.
