Skip header
ManualsContentsPreviousNextHelp

Basic Procedure for Saving Scan Files on a Removable Memory Device

Use the following procedure to save scan files on a removable memory device.

  1. Insert a removable memory device in the media slot.

    You can connect only one removable memory device at a time.

  2. Close the media slot cover.

    If you leave the cover open, static electricity conducted through an inserted SD card could cause the machine to malfunction.

  3. Make sure that no previous settings remain.

    If a previous setting remains, press the [Clear Modes] key.

  4. Place originals.

  5. Press [Store File].

  6. Press [Store to Memory Device].

    Operation panel screen illustration

  7. Press [OK].

  8. If necessary, press [Scan Settings] to specify scanner settings such as resolution and scan size.

    For details, see "Various Scan Settings".

    Operation panel screen illustration

  9. If necessary, specify the scanning density.

    For details, see "Adjusting Image Density".

  10. If necessary, press [Original Feed Type] to specify settings such as original orientation.

    For details, see "Setting of Original Feed Type".

  11. If necessary, press [Send File Type / Name] to specify settings such as file format and file name.

    For details, see "Specifying the File Type and File Name".

  12. Press the [Start] key.

    When scanning batches, place subsequent originals after the scan files have been sent.

    When writing is complete, a confirmation message appears.

  13. Press [Exit].

  14. Remove the memory device from the media slot.

    Do not remove the memory device while writing is in process. Doing so can corrupt the data that is stored on it.

Note

Reference