Skip header
 

Stamp

This section explains the procedure for stamping originals that are scanned from the ADF. The stamp indicates the originals have been scanned.

When scanning a document using ADF, the machine can stamp a circle mark at the bottom of the original. When scanning a two-sided document, the document is marked at the bottom of the front page and top of the rear page.

This function is useful when you want to distinguish scanned originals.

Illustration of stamp

1Press [Original Feed Type].

2Press [Stamp].

Operation panel screen illustration

3Press [OK].

Note

  • The stamp position varies depending on the machine type.

  • Last pages are stamped even if you selected not to scan the last page.

  • Stamping may continue if scanning is interrupted, depending on the cause of interruption.

  • Replace the stamp cartridge when stamp begins to fade. For details, see "Replacing the Stamp Cartridge", Troubleshooting.