Skip header
 

Basic Procedure for Storing Scan Files

This section explains the basic procedure for storing scan files.

1Make sure that no previous settings remain.

If a previous setting remains, press the [Clear Modes] key.

2Place originals.

3Press [Store File].

Operation panel screen illustration

4Press [Store to HDD].

5If necessary, specify file information, such as [User Name], [File Name], and [Password].

For details, see "Specifying File Information for a Stored File".

6Press [OK].

7If necessary, press [Scan Settings] to specify scanner settings such as resolution and scan size.

For details, see "Various Scan Settings".

Operation panel screen illustration

8If necessary, specify the scanning density.

For details, see "Adjusting Image Density".

9If necessary, press [Original Feed Type] to specify settings such as original orientation.

For details, see "Setting of Original Feed Type".

10Press the [Start] key.

If you are scanning batches, place the next originals.

11Press [OK].

Note

  • Depending on the security setting, [Access Privileges] may appear instead of [User Name]. For details about specifying [Access Privileges], consult the administrator.

  • By pressing [Store to HDD + Send], you can simultaneously store scan files and send them. For details, see "Simultaneous Storage and Sending by E-mail", "Simultaneous Storage and Sending by Scan to Folder", and "Simultaneous Storage and Delivery".

  • You cannot press [Store File] if:

    • "PDF" is selected as the file type and security is applied

    • High Compression PDF is selected as the file type

  • You cannot specify [Store to HDD] if:

    • a destination is specified

    • [Preview] is selected

  • To cancel scanning, press the [Clear/Stop] key.

  • After an e-mail is sent, the file information fields will be automatically cleared. If you want to preserve the information in these fields, contact your local dealer.