Skip headerimage
ManualsContentsPreviousNextHelp

Registering a Protection Code to a Single User

This section describes how to register a Protection code to a single user.

  1. Press the [User Tools/Counter] key.

  2. Press [System Settings].

    Operation panel screen illustration

  3. Press [Administrator Tools].

  4. Press [Address Book Management].

  5. Check that [Program / Change] is selected.

  6. Select the name whose protection code you want to register.

    You can search by the registered name, fax number, folder name, e-mail address, or IP-Fax destination.

  7. Press [Protection].

    Operation panel screen illustration

  8. Press [Destination] or [Sender] under "Use Name as".

    Operation panel screen illustration

    Both [Destination] and [Sender] can be selected at the same time.

  9. Press [Change] under "Protection Code".

  10. Enter a protection code using the number keys, and then press the [Hash] key.

  11. Press [OK].

  12. Press [Exit].

  13. Press the [User Tools/Counter] key.

Note