Skip header
 

Registering an SMB Folder

This section describes how to register an SMB folder.

1Press the [User Tools/Counter] key.

2Press [System Settings].

Operation panel screen illustration

3Press [Administrator Tools].

4Press [Address Book Management].

5Check that [Program / Change] is selected.

6Select the name whose folder you want to register.

Press the name key, or enter the registered number using the number keys.

7Press [Auth. Info], and then press [Down arrow keyNext].

Operation panel screen illustration

8Press [Specify Other Auth. Info] on the right side of Folder Authentication.

When [Do not Specify] is selected, the SMB User Name and SMB Password that you have specified in Default User Name/Password (Send) of File Transfer settings applies.

9Press [Change] under "Login User Name".

10Enter the login user name, and then press [OK].

11Press [Change] under "Login Password".

12Enter the password, and then press [OK].

13Enter the password again to confirm, and then press [OK].

14Press [Folder].

15Press [SMB].

To specify a folder, you can either enter the path manually or locate the folder by browsing the network.

Operation panel screen illustration

16Specify the path.

For details about how to specify the path manually, see "Locating the SMB folder manually".

For details about how to specify the path using Browse Network, see "Locating the SMB folder using Browse Network".

17Press [Connection Test] to check the path is set correctly.

18Press [Exit].

If the connection test fails, check the settings, and then try again.

19Press [OK].

20Press [Exit].

21Press the [User Tools/Counter] key.

Note

  • To register the name, see "Registering Names".

  • You can enter up to 64 characters for the user name.

  • You can enter up to 64 characters for the password.

  • You can enter a path using up to 128 characters.

  • If User Authentication is specified, contact your administrator.