Skip header
 

Top Page > About This Machine > Adding Paper > Loading Paper > Loading Paper into Tray 3 (LCT)

Loading Paper into Tray 3 (LCT)

This section describes how to load paper into tray 3 (LCT).

Important

  • Tray 3 (LCT) uses A4Portrait paper exclusively. Only load A4Portrait paper. If you want to load 81/2 × 11Portrait, contact your service representative.

  • Align the paper stacks and load them against the left and right walls, or a paper misfeed might occur.

  • Each tray hold up to 1,000 sheets of paper. Do not stack paper over the limit mark.

1Carefully pull out tray 3 (LCT) until it stops.

Tray 3 (LCT) illustration

2With the print side up, align all four sides of two paper stacks, and then load them next to each other in the tray.

Tray 3 (LCT) illustration

3Carefully push the paper tray fully in.