Skip headerimage
ManualsContentsPreviousNextHelp

Function Compatibility

The combination chart given below shows which modes can be used together.

Blank: These modes can be used together.

×: These modes cannot be used together. The first mode selected will be the mode you are working in.

image: These modes cannot be used together. The second mode selected will be the mode you are working in.

The following combinations are not possible.

×1: 2 Sided 1 Sided with Covers or Slip Sheet

×2: Staple: Top with Punch: Left, Staple: Centre with Punch: Left, Staple: Centre with Punch: Top, Staple: Left with Punch: Top,

The following shows the combinations of functions:

Illustration of function compatibility

Illustration of function compatibility

*1 You can use these combinations, but the functions indicated will not be applied to the binding margin.

*2 You can use these combinations only if the hard disk is installed.

*3 You cannot combine this with "Original Orientation (90 degree Turn)" if the machine is set to staple one part only. (The first mode selected will be the mode you are working in.)