



	Manuals Contents Previous Next

Top Page > Troubleshooting > Clearing Misfeeds > Removing Punch Waste > Booklet Finisher SR 3000

Booklet Finisher SR 3000

This section describes how to remove punch wastes from the Booklet Finisher SR 3000.

Open the finisher front cover.
Pull out the punch waste box carefully, and then remove punch waste.
Reinstall the punch waste box.
Close the finisher front cover.
"Hole Punch Receptacle is full." disappears.

The message "Hole Punch Receptacle is full." may appear even when the punch waste box is not yet full. If this happens, the position of the punch waste box (indicated by the arrow as shown) may be blocked by punch waste. Remove the punch waste.