When an indicator to the right of a function key lights up, press the corresponding function key. Then, follow the instructions displayed on the control panel.
If an error occurs in the function you are using, check the message that appears on the control panel, and then refer to "Messages Displayed" for the relevant function.
The following table explains problems that cause the indicator to light.
Problem |
Cause |
Solution |
---|---|---|
Documents and reports do not print out. |
The paper output tray is full. |
Remove the prints from the tray. |
Documents and reports do not print out. |
There is no paper left. |
Load paper. See "Loading Paper", About This Machine |
An error has occurred. |
The function whose indicator is lit is defective. |
Record the code number shown on the display and contact your service representative. See "Messages Displayed" of each chapter. You can use other functions normally. |
The machine is unable to connect to the network. |
A network error has occurred. |
|