Skip headerimage
ManualsContentsPreviousNextHelp

Setting Paper on the Bypass Tray

This section gives instructions for setting paper on the bypass tray.

For details about paper size and paper type, see "Paper Size and Paper Type", About This Machine.

Important

  1. Open the bypass tray.

    Bypass tray illustration

  2. Gently insert paper face up into the bypass tray until the beeper sounds, and then adjust the paper guides to the paper size.

    If the paper size of the paper guide and the paper do not match, skewing and misfeeds might occur.

    Do not stack paper over the limit mark, otherwise a skewed image or misfeeds might occur.

    Open out the extender to support paper sizes larger than A4Landscape, 81/2 × 11 inLandscape.

    Fan the paper to get air between the sheets to avoid a multi-sheet feed.

    Bypass tray illustration numbered callout illustration

    1. Paper Guide

    2. Extender

  3. Set the paper size using the printer driver or the control panel.

Note

Related topics

Setting the Paper Size Using the Control Panel
Setting Custom Size Paper Using the Control Panel
Setting Thick Paper, Thin Paper, or OHP Transparencies Using the Control Panel
Setting Envelopes Using the Control Panel