Skip headerimage
ManualsContentsPreviousNextHelp

Programming/Changing Information Boxes

This section describes how to set up an Information Box.

You can store the following items:

  1. Press [Facsimile Features].

  2. Press [General Settings].

  3. Press [Box Setting].

  4. Check that [Program / Change] is selected.

  5. Select the box to program.

    When programming a new box, press [Not Programmed].

    Operation panel screen illustration

    To change a box already programmed, press it, and then proceed to step 8. If a password is programmed, enter the password, press [OK], and then proceed to step 8.

  6. Press [Information Box].

  7. Enter a box name, and then press [OK].

  8. Enter the SEP Code.

    Operation panel screen illustration

    To change the SEP Code, press [Clear] or the [Clear/Stop] key, and then try again. To change the box name, press [Box Name], and then repeat the procedure from step 7.

  9. Press [Password].

    If you do not want to program a password, proceed to step 12.

  10. Enter a password, and then press [OK].

    Operation panel screen illustration

    If you make a mistake, press [Clear] or the [Clear/Stop] key before pressing [OK], and then try again.

  11. Re-enter the password, and then press [OK].

    If you make a mistake, press [Clear] or the [Clear/Stop] key before pressing [OK], and then try again.

  12. Press [OK].

  13. Press [Exit].

  14. Press the [User Tools/Counter] key.

Note

Reference