Skip headerimage
ManualsContentsPreviousNextHelp

When an Indicator to the Right of a Function Key Is Lit

When an indicator to the right of a function key lights up, press the corresponding function key. Then, follow the instructions displayed on the control panel.

Function key illustration

If an error occurs in the function you are using, check the message that appears on the control panel, and then refer to "Messages Displayed" for the relevant function.

The following table explains problems that cause the indicator to light.

Problem

Cause

Solution

Documents and reports do not print out.

The paper output tray is full.

Remove the prints from the tray.

Documents and reports do not print out.

There is no paper left.

Load paper. See "Loading Paper", About This Machine Illustration indicating book format instructionsIllustration indicating instructions stored on a CD-ROM.

An error has occurred.

The function whose indicator is lit is defective.

Record the code number shown on the display and contact your service representative. See "Messages Displayed" of each chapter.

You can use other functions normally.

The machine is unable to connect to the network.

A network error has occurred.

  • Check the displayed message and take an appropriate action. See "Messages Displayed" of each chapter.

  • Check that the machine is correctly connected to the network, and that the machine is correctly set. For details about how to connect the network, see "Connecting the Machine", Network and System Settings Guide Illustration indicating instructions stored on a CD-ROM.

  • Contact the network administrator.

  • If the indicator is still lit even after trying to solve the problem as described here, contact your service representative.