PS Menu

You can specify how long the printer waits (in seconds) before cancelling the current job when the job is interrupted while being processed.

The default setting is [Use Driver / Command].

If you select [Use Machine Settings], enter a value between 0 and 999.

The default setting is "0".

"0" does not mean timeout.

You can specify how long the printer waits (in seconds) before it cancels receiving the job when the printer cannot detect the end of the job.

The default setting is [Use Driver / Command].

If you select [Use Machine Settings], enter a value between 0 and 999.

The default setting is "300".

"0" does not mean timeout.

You can select a data format.

The default setting is [TBCP].

This setting is not effective when operating the machine with a parallel or EtherTalk connection.

When operating the machine with a parallel connection, and also if the binary data is sent from the printer driver, the print job is canceled.

When operating the machine with an Ethernet connection, the print job is canceled under the following conditions:

• The printer driver data format is TBCP, and the data format selected on the display panel is Binary Data.

• The printer driver data format is binary, and the data format selected on the display panel is TBCP.

You can set the print resolution in dots per inch.

The default setting is [600 dpi (Fast)].

You can make an RGB setting.

The default setting is [Super Fine].

You can set the colour profile.

The default setting is [Auto].

Specify the colour model.

The default setting is [Color (Colour)].