Skip headerimage
ManualsContentsPreviousNextHelp

Connecting to the Gigabit Ethernet Interface

This section describes how to connect the Ethernet interface cable to the Gigabit Ethernet port.

Important

  1. Make a loop at both ends of the Ethernet interface cable 5 cm (2.1 inch) (1) from the end, and install the included core.

    illustration of Ethernet cable with ferrite core

  2. Make sure the main power switch of the machine is off.

  3. Connect the Ethernet interface cable to the Gigabit Ethernet port.

    illustration of connecting Ethernet cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    Gigabit Ethernet port illustration (numbered callout illustration)

    1. Indicator (yellow)

      When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned off.

    2. Indicator (green)

      When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned off.

    3. Indicators (both yellow and green)

      When 1000BASE-T is operating, both LED are lit.

Note