Skip headerimage
ManualsContentsPreviousNextHelp

Registering the user stamp

Scans an image that is used as a user stamp.

The range of stamp images is 10 - 297 mm (0.4 - 11.7 inches) high and 10 - 432 mm (0.4 - 17.0 inches) wide. However, if the value exceeds the maximum value of the area (5,000 mm2, 7.75 inch2), it is corrected within the range of the area automatically.

Up to four frequently used images can be stored in memory.

Illustration of User Stamp

  1. Base point

  2. Exposure glass

  1. Press the [User Tools/Counter] key.

    User Tools/Counter key illustration

  2. Press [Copier / Document Server Features].

    Operation panel screen illustration

  3. Press [Stamp].

  4. Press [User Stamp].

  5. Press [Program / Delete Stamp].

  6. Press [Program], and then press the stamp number you want to program.

  7. Enter the user stamp name (up to ten characters) with the letter keys, and then press [OK].

  8. Enter the horizontal size of the stamp with the number keys, and then press [Sharp].

  9. Enter the vertical size of the stamp with the number keys, and then press [Sharp].

  10. Place the original for user stamp on the exposure glass, and then press [Start Scanning].

    The original will be scanned, and the stamp will be registered.

  11. Press [Exit].

  12. Press [Exit].

    The display returns to the User Tools/Counter/Enquiry screen.

  13. Press [Exit].

    Exits settings and gets ready to copy.

Note