Skip header
ManualsContentsPreviousNextHelp

Label paper

Printer setup

Press the [Menu] key, Select [Paper Input], [Paper Type: (tray name)], and then select [Label Paper].

Printer driver setup

Click [Labels] in the [Paper Type:] list.

Supported paper feeding tray

Any input tray can be used.

Make sure paper is not stacked higher than the upper limit mark (Down arrow key) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides inside it.

Duplex printing

Not supported

Label paper setup

Default: [Label Paper 2]

If the printing result is badly wet or smudged, change the setting on the printer's control panel as the following:

  • Press the [Menu] key, select [Maintenance], [General Settings], and then select [Label Paper Setting]. Select one from [Label Paper 1], [Label Paper 2], or [Label Paper 3]. The greater number corresponds to the thicker setting. The one of these items is normally detected automatically according to the paper type you set. It is not necessary to change this setting when the printing result has no problem.