Manuals
Contents
Previous
Next
| | | |
| |||
| |||
| | | |
| ManualsContentsPreviousNext | | |
This section describes handling the controller board when installing options.
If you slide out the controller board to install the SDRAM module, the user account enhance unit, or the printer hard disk, carefully follow the instruction below to re-install the controller board.
The following may occur if the controller board is not correctly installed:
All control panel indicators are lit.
No control panel indicators are lit.
The "SC670" error message appears on the display.
Re-install the controller board into the printer by pushing the bottom center area of the board, as shown in the illustration.
 |
 | Copyright (C) 2007 |
