Setting the Ethernet Speed
Set the access speed for Ethernet. Confirm your network environment, and then select a speed that matches it using the following table.
Router/HUB |
Printer |
||||
|---|---|---|---|---|---|
10Mbps Half D. |
10Mbps Full D. |
100Mbps Half D. |
100Mbps Full D. |
Auto Select |
|
10 Mbps half duplex |
|
- |
- |
- |
|
10 Mbps full duplex |
- |
|
- |
- |
- |
100 Mbps half duplex |
- |
- |
|
- |
|
100 Mbps full duplex |
- |
- |
- |
|
- |
auto-negotiation (auto selection) |
|
- |
|
- |
|
Connection cannot be established if the Ethernet speed does not match your network's transmission speed.
The auto-negotiation mechanism allows two interfaces to automatically determine an optimum Ethernet speed as soon as they are connected. We recommend you select [Auto Select].
Press the [Menu] key.
The [Menu] screen appears.
Press the [
] or [
] key to display [Host Interface], and then press the [
Enter] key.
Press the [] or [] key to display [Network Setup], and then press the [ Enter] key.
Press the [] or [] key to display [Ethernet Speed], and then press the [ Enter] key.
Press the [] or [] key to select the ethernet speed, and then press the [ Enter] key.
Press the [Online] key.
The initial screen appears.
Print a configuration page to confirm the settings made.
If Ethernet and wireless LAN are both connected, select which interface you want to use under [LAN Type].
For details about printing the configuration page, see "Printing the Test Page", Quick Installation Guide.
"Printing the Test Page", Quick Installation Guide.
