Skip header
 

Top Page > Hardware Guide > Guide to the Printer > Exterior

Exterior

image

  1. Paper Size Dial

    Adjust this dial to match the size and feed direction of the paper loaded in the paper tray.

  2. Bypass Tray Extension

    Pull out this extension to load paper into the Bypass Tray when its length is longer than B5image.

  3. Bypass Tray

    Use this tray to print onto thick paper, OHP transparencies, adhesive labels, envelopes as well as plain paper. When printing on custom paper size, printer driver settings are required.

    Up to 100 sheets of plain paper (80 g/m2, 20 lb.) can be loaded.

    See Paper and Other Media Supported by This Printer and Loading Paper.

  4. Control Panel

    Contains keys for the printer operation and display that shows the printer status.

  5. Tray Extension

    Pull out this extension when paper's length is longer than B5.

  6. Output Tray (Standard Tray)

    Stacks printed output with the print side facing down.

  7. Paper Exit Cover

    Open this cover to remove misfed paper.

  8. Ventilator

    Helps to keep components inside the printer from overheating.

    Do not block or obstruct this hole. A malfunction may occur due to overheating.

  9. Front Cover Release Button

    Use this button to open the front cover.

  10. Power Switch

    Use this switch to turn the printer power on and off.

  11. Paper Tray (Tray 1)

    Loads up to 500 sheets of plain paper (80 g/m2, 20 lb.) into this tray for printing.

    The paper tray is displayed with “Tray 1” on the display.

  12. Friction pad

    This is provided to feed one sheet of paper at a time. Clean the friction pad when more than one sheet of paper is fed into the printer. Also, replace the friction pad when the message “Replace Maintenance Kit”, appears.

  13. Paper Tray Cover

    Prevents paper inside the tray from getting dirty.

  14. Power Port

    Connect the power cable to this port and the other end of the cable to the outlet.

  15. Rear Cover

    Remove this cover to install the optional duplex unit or to replace the fusing unit.

  16. Ventilators

    Help to keep components inside the printer from overheating.

    Do not block or obstruct these holes. A malfunction may occur due to overheating.

  17. Controller Board

    Slide it out to install the optional memory unit.

    Plug cables such as the ethernet cable, USB cable and parallel interface cable and into their connectors.