Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Hardware Guide > Appendix > Moving and Transporting the Printer > Moving the Printer > Moving the printer a short distance

Moving the printer a short distance

Important

  1. Be sure to check the following points:

    • The power switch is turned off.

    • The power cord is unplugged from the wall outlet.

    • The interface cable is unplugged from the printer.

  2. If any external options are attached, remove them.

    See the relevant sections in this manual and reverse the steps to remove options.

  3. Pull out the handle from the right side of the printer.

    Exterior front view illustration

  4. Lift the printer with four people by using the handles on both sides of the printer, and then move it to the place where you want to install it, keeping it horizontal.

    Exterior front view illustration

  5. Return the handle you pulled out from the printer to its original position.

  6. If you removed options, reattach them.

    For details, see the relevant sections in this manual.

    Note

    • At least four people are required to lift the printer.

    • Be sure to keep the printer horizontal while moving it. To prevent toner from being released, move the printer slowly.

    • If optional paper feed units are attached, remove them from the printer and move them separately.

    • When finished, return the handles to their original position.

TopPreviousNext
Copyright (C) 2007