Skip headerimage
ManualsContentsPreviousNextHelp

Receiving an IP Address Automatically (DHCP)

Follow this procedure to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.

Important

  1. Press the [Menu] key.

    Menu key illustration

  2. Press the [Down arrow key] or [Up arrow key] key to select [Host Interface], and then press the [OK] key.

    Operation panel screen illustration

  3. Press the [Down arrow key] or [Up arrow key] key to select [Network], and then press the [OK] key.

    Operation panel screen illustration

  4. Press the [Down arrow key] or [Up arrow key] key to select [Machine IPv4 Address], and then press the [OK] key.

    Operation panel screen illustration

  5. Press the [Down arrow key] or [Up arrow key] key to select [Auto-Obtain (DHCP)], and then press the [OK] key.

    Operation panel screen illustration

    The printer will automatically receive an IP address.

    To check the detected addresses, press the following:

    • [IP Add.] : IP address

    • [Subnet M] : Subnet mask

    • [Gateway] : Gateway address

  6. Press the [Menu] key to return to the initial screen.

  7. Print a configuration page to confirm the settings.

Note