Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Hardware Guide > Guide to the Printer > Exterior: Rear View

Exterior: Rear View

This section explains names and functions of the parts on the rear side of the printer.

Exterior rear view numbered callout illustration

  1. Optional Interface Board Slot

    Install an optional interface board. The Gigabit Ethernet board, Wireless LAN board, or IEEE1284 interface board can be installed.

  2. USB Port A

    This port is usually not used.

  3. Controller Board

    Slide this out to install the hard disk or SDRAM module.

  4. Power Connector

    Connect the power cord to the printer. Insert the other end of the cable into an electrical outlet.

  5. SD Card Slots

    Remove the cover and install the SD cards. Install the data overwrite security unit, data storage card, or IPDS unit in the upper slot. Install the HDD encryption unit or VM card in the lower slot.

  6. Ethernet Port

    Use a network interface cable to connect the printer to the network.

  7. USB Port B

    Use a USB cable to connect the printer to a computer.

  8. Handle

    Hold this handle when you pull out the controller board.

TopPreviousNext
Copyright (C) 2007