The Preview Before Transmission function allows you to check the content of a scanned original before you send it.
To use this function, the optional HDD unit is required.
This function cannot be used with the following functions:
Immediate Transmission
Parallel Memory Transmission
On Hook Dial
Manual Dial
SEP Code Reception
When [Store Only] is set for [Store File]
Transmission of a stored file only
Place the original, and then specify the scan settings you require.
Specify the “Original Orientation” setting correctly. If you do not, the top/bottom orientation of the original will not be displayed correctly in the preview.
For details about the setting, see “Setting the Original Orientation”.
Press [Preview].
Specify the destination, and then press the [Start] key.
The machine starts to scan the original. When scanning ends, a preview is displayed.
If you want to cancel a preview, press [Cancel].
Check the preview.
Press [Zoom Out] or [Zoom In] to reduce or enlarge the preview image.
Press [] [
] [
] [
] to scroll the preview image.
Press [Switch] under “Display File” to display another selected file.
Press [Switch] under “Display Page” to change the displayed page.
Press [Send].
Transmission starts.
To cancel the transmission, press [Cancel Sending].
After transmission, the standby display appears.
You can have the machine select Preview Before Transmission right after the power is turned on or whenever the [Clear Modes] key is pressed. For details, see “Setting Transmission Function Defaults”.