Changing the Paper Size in the Paper Trays

This section describes how to change the paper size in the paper trays.

If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Do not stack paper over the limit mark.
Check the paper edges are aligned with the right side.
When loading small quantities of paper, be careful not to squeeze the side fences in too tightly, as the paper will not feed properly.

Make sure the paper tray is not in use.
Pull the paper tray out slowly until it stops.
Remove any remaining copy paper.
While pinching the release lever, slide the end fence outward.
Press down the release button.
While pressing the release lever, slide the side fences outward.
Square the paper and place it print side up.
Do not stack paper over the limit mark.
While pressing the release lever, push in the side and end fences until they are flush against the paper's edges.
Press down the lock button.
Push the paper tray in until it stops.