



	Manuals Contents Previous Next

Top Page > Troubleshooting > Remarks > Where to Put Your Machine > Power Connection

Power Connection

This section describes power supply.

Connect the machine only to the power source described on the inside front cover of this manual. Connect the power cord directly into a wall outlet and do not use an extension cord.
Do not damage, break or make any modifications to the power cord. Do not place heavy objects on it. Do not pull it hard nor bend it more than necessary. These actions could cause an electric shock or fire.

If the power cord is damaged (exposure of the core, disconnection, etc.), contact your service representative to change a new one. Operating the machine with a damaged power cord may cause an electric shock or fire.

When you disconnect the power plug from the wall outlet, always pull the plug (not the cable).

To disconnect the power cord, pull it out by plug. Do not drag the cord itself. Doing so may result in damage to the cord, leading to fire or electric shock.

When the main power switch is in the stand-by position, the optional anti-condensation heaters are on. In an emergency, unplug the machine's power cord.
When you unplug the power cord, the anti-condensation heaters turn off.
Make sure the plug is inserted firmly in the wall outlet.
Voltage must not fluctuate by more than 10%.
The wall outlet shall be installed near the machine and shall be easily accessible.