Skip header
For screen readerStandard Web browser page
 

Top Page > Preparing for Printing > Setting Up the Hardware > Attaching the Options > Attaching the Duplex Unit AD1020

Attaching the Duplex Unit AD1020

  1. Make sure the printer's power cord is unplugged.

  2. Take the duplex unit out of its box.

  3. Remove the orange tape from the duplex unit.

  4. Remove the rear cover.

    image

  5. Fully insert the duplex unit.

    Paper jams can occur if the unit is not properly connected. Be sure to push the unit firmly into position.

    image

Note

  • Dispose of the removed component as general plastic waste or hand it in for collection.