ContentsPreviousNext |
In the Host I/F Settings menu, you can make network settings and settings for the computer to machine USB connection (if used). Settings made using the Host I/F Settings menu remain effective even if you turn the machine off.
I/O Timeout
Specify how long the machine waits for the currently-connected interface to respond. When the specified time elapses, the machine can receive data from another interface.
If you make the [I/O Timeout] period too short, timeout might occur while data transfer is in progress. If this happens, the print job will be interrupted by a new job from another interface.
You can specify 10, 15, 20, 25, 60 seconds.
The default setting is 15 second(s).
USB Speed
You can specify the settings related to communication when the computer and machine are connected via USB. Usually, you do not need to change these settings.
Usually, you do not need to change these settings.
After changing this setting, turn the machine off and then back on.
Full Speed
Auto
The default setting is “Auto”.
Fixed USB Port
You can specify the settings related to communication when the computer and machine are connected via USB. Usually, you do not need to change these settings.
Usually, you do not need to change these settings.
On
Off
The default setting is “Off”.
Auto Email Notf.
You can specify whether or not to send notification that a machine error has occurred to a particular e-mail address.
After changing this setting, turn the machine off and then back on.
On
Off
The default setting is “On”.
[Auto Email Notf.] can only be specified using the Web browser. For details, see Notifying the Machine Status by E-mail.