ContentsPreviousNext |
This section describes the Engine Setting menu (Engine Settings).
Paper Tray Prty.
You can specify the prioritized paper feed tray.
The default setting is “Tray 1”.
List/Test Print
You can print lists of configurations on machine or the paper printings.
Configuration Page
You can print the current configuration of the machine.
PCL Configuration (GX 3050SFN only)
You can print the current configuration of the machine.
Pg-dry Prt.Delay
To prevent spoiling of duplex-printed copies or to prevent inkjet-printed transparencies sticking together, select a print delivery interval to allow them to dry. The interval must be long enough to allow a duplex-printed or an inkjet-printed transparency sheet to dry.
Duplex Unit
On
Off
Having selected [On], press the [] or [] key to specify how long to wait for the ink to dry. You can specify 1, 2, 5, 10, 15, or 20 seconds.
The default setting is “Off”.
Transparency
On
Off
Having selected [On], press the [] or [] key to specify how long to wait for the ink to dry. You can specify 1, 2, 5, or 10 minutes.
The default setting is “Off”.
Auto Continue
You can select this to enable Auto Continue. When it is On, printing continues after a system error occurs.
When this is set to “Off”, an alarm indicator lights if an error occurs and the machine stops.
When this is set to “Immediate”, the machine ignores errors and continues printing.
Off
Immediate
The default setting is “Immediate”.
Sub Paper Size
You can enable the auto substitute paper size (A4 and LT) feature.
If you select [Auto] but paper of the required size is not available, the machine prints on A4 or letter-size (81/2" 11") paper instead. If you select [Off], the machine does not switch to alternative paper.
Off
Auto
The default setting is “Off”.
Uni-directn.Prnt
Specify whether to print unidirectionally or bidirectionally.
Unidirectional printing produces higher quality print, but bidirectional printing is faster.
Env.Selector:On
Printing is done unidirectionally or bidirectionally according to the envelope selector position.
If the envelope selector is set to the rear position , printing is done unidirectionally.
If the envelope selector is set to the forward position , printing is done unidirectionally or bidirectionally according to the paper type.
AutoDetectPpr/Mode
Printing is done unidirectionally or bidirectionally according to the paper type, regardless of the envelope selector position.
Always Uni-dir.
Printing is always done unidirectionally, regardless of the envelope selector position.
Default: Env.Selector:On
Replace Ink Collector Unit
Contact your service representative when replacing the ink collector unit.