Skip header
Screen reader supported pageStandard
 

Sending a Fax Using the On Hook Dial Function

The On Hook Dial function allows you to dial while listening to the tone from the internal speaker. You can send a fax checking the connection.

This function is available in immediate transmission mode only.

This function is not available for Internet Fax.

1Press the [Memory Trans.] key.

panel keys illustration

Make sure the [Memory Trans.] indicator is unlit.

2Place the original.

16:00    Std    100%
 -Set Orig- Fax Only

To change the scan settings, press the [Resolution] key, and then specify the settings.

3Press the [On Hook Dial] key.

panel keys illustration

*On-hook*           
                    

You will hear a low tone from the internal speaker.

To cancel this operation, press the [On Hook Dial] key again, or press the [Clear/Stop] key.

4Specify the destination.

=123456           
                    

If you have specified the destination using the [Quick Dial] key, proceed to step 6.

If you make a mistake, press the [Clear/Stop] key, and then enter the correct number.

5Press the [B&W Start] key.

panel keys illustration

6When the line is connected and you hear a high-pitched tone, press the [B&W Start] key.

panel keys illustration

The transmission starts.

After transmission, the initial screen appears.

To cancel a transmission, press the [Clear/Stop] key, and then remove the originals.

Note

  • This function is unavailable in some countries.