Sending a Fax by Memory Transmission Mode
You can use memory transmission mode to send both normal and Internet Faxes. You can also use this mode to send a fax at a specified time or to multiple destinations.
If memory is full (When [Memory Full] appears on the display), memory transmission is disabled. Use immediate transmission instead.
The display shows the percentage of free memory space for storing originals.
Press the [Fax] key, and make sure the [Memory Trans.] indicator lights.
Normally memory transmission mode is selected.
If it is not, immediate transmission mode is selected. Press the [Memory Trans.] key.
Place the original.
| 16:00 Std 100% -Set Orig- Fax Only |
To change the scan settings, press the [Resolution] key, and then specify the settings.
Specify the destination.
  SUB=  [1] |
If you press a Quick Dial key, the destination assigned to it appears on the display and transmission begins automatically. You do not have to press the [B&W Start] key as in step 
. (below).
If you make a mistake, press the [Clear/Stop] key, and then enter the correct number.
Press the [B&W Start] key.
The transmission starts.
After transmission, the initial screen appears.
To cancel a fax during sending, press the [Clear/Stop] key, and then remove the original.
In [TX Settings], you can select memory transmission as the default fax mode.
