Loading paper into tray 1
Follow the procedure below to load paper into tray 1.
A4/Letter size paper is loaded here.
Lift the output tray.
Hold the Tray 1 grip, pull the tray halfway out, lift it slightly, and then pull it out further.
Pull tray 1 completely out. Take care not to drop it.
Squeeze the paper guides on right side, and then adjust them according to the paper size.
Beforehand, make sure to squeeze the front end paper guide, and then expand the guide.
Load paper with the print side face down but not over the limit mark.
Load paper according to the capacity of the tray.
Squeeze the front end paper guide, and then slide it to meet the edge of the paper.
Hold both sides of tray 1, and push it gently in until it stops.
Lower the output tray.
