This section describes the common network settings.
Settings |
Descriptions |
---|---|
devicename.name = <text> |
Specify the name of the machine using up to 31 characters. |
smb.comment = <text> |
Specify a comment using up to 31 characters. |
set.ipv6 = {1|0} |
Enable or disable IPv6.
|
set.netware = {1|0} |
Enable or disable NetWare.
|
set.smb = {1|0} |
Enable or disable SMB.
|
set.diprint = {1|0} |
Enable or disable DIPRINT.
|
etherconfig.speed = {AutoNego|10full|10half|100full|100half} |
Specify an Ethernet speed from the following:
|
spoolsw.spool = {1|0} |
Enable or disable the Job Spool settings.
|
spoolsw.clearjob = {1|0} |
Specify whether or not to reset spooled jobs when you turn off the machine while printing a spooled job and turn it on again.
|
spoolsw.lpr = {1|0} |
Enable or disable the Job Spool settings when using LPR.
|
spoolsw.ftp = {1|0} |
Enable or disable the Job Spool settings when using FTP.
|
spoolsw.ipp = {1|0} |
Enable or disable the Job Spool settings when using IPP.
|
spoolsw.smb = {1|0} |
Enable or disable the Job Spool settings when using SMB.
|
spoolsw.diprint = {1|0} |
Enable or disable the Job Spool settings when using DIPRINT.
|
spoolsw.sftp = {1|0} |
Enable or disable the Job Spool settings when using SFTP.
|
spoolsw.wsprn = {1|0} |
Enable or disable the Job Spool settings when using WSD (Printer).
|
authfree.<registry number>.range.from = {0.0.0.0–255.255.255.255} |
Specify the starting IPv4 address such as 0.0.0.0, 0.0.0.200, etc. You can specify up to five IPv4 address ranges for the registry number by using numerals from 1 to 5. |
authfree.<registry number>.range.to = {0.0.0.0–255.255.255.255} |
Specify an ending IPv4 address that is compatible with the starting IPv4 address. You can specify up to five IPv4 address ranges for the registry number by using numerals from 1 to 5. |