Skip headerimage
ManualsContentsPreviousNextHelp

Installing the SD Card Provided with the Machine

This section describes how to install the SD card.

WARNING


  • Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside this machine are high voltage components that are an electric shock hazard and laser components that could cause blindness. Contact your sales or service representative if any of the machine's internal components require maintenance, adjustment, or repair.

  • Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock. Note again that exposure to the laser components inside this machine risks blindness.

CAUTION


  • Keep SD cards out of reach of children. If a child swallows an SD card, consult a doctor immediately.

Important

The following SD cards are provided with the machine:

  1. Check the contents of the package.

    SD card illustration

  2. Turn off the main power switch, and then unplug the machine's power cord from the wall outlet.

  3. Loosen and remove the screw, and then carefully remove the cover of the SD card slot.

    Rear side of the machine illustration

  4. Carefully push in the SD card (notched corner downward and leading), until it clicks into place.

    Rear side of the machine illustration

    Insert the SD card in the lower slot.

  5. Reattach the cover over the SD card. Fasten the screw to secure the cover.

    Rear side of the machine illustration

Note